Hypercom 1101 Network Router User Manual


 
Trap Definitions
94 Hypercom Corporation
SNMP Variables Used for Setting Time
The following variables are provided in order to use SNMP to configure SNTP:
Switched to Alternate Host (7) (trapSwitchedToAlternate) Issued when switching to alternate IP
address due to loss of keep alive or loss of
TCP session when in permanent TCP
mode
Invalid Terminal Message (8) (trapInvalidTerminalMessage) Issued when an improperly formatted
message is received from a terminal
Terminal Poll Lost (9) (trapTerminalPollLost) Issued when a transition from receiving
responses to SDLC poll to no response is
detected
Terminal Poll Restored (10) (trapTerminalPollRestored) Issued when a transition from no poll
response to receiving a poll response is
detected
Admin Logged In (11) (trapAdminLoggedIn) Issued whenever anyone logs in to the
IN-tact 1101 using the “admin” User ID
and password
Admin Logged Out (12) (trapAdminLoggedOut) Issued whenever “admin” logs out of the
IN-tact 1101
Admin Password Changed (13) (trapAdminPasswordChanged) Issued whenever the password for the
User ID “admin” is changed
Session Timed Out (14) (trapSessionTimedOut) Issued when the five-minute timer expires
during a session. The session is closed
and the user is logged out
Maximum Failed Login Attempts
(15)
(trapMaxFiledLoginAttempts) Issued whenever the three consecutive
failed attempts were made to log in to the
IN-tact 1101
System Error (99) (trapSystemError) Issued when the device detects an
unexpected condition. A four-digit code
within the trap identifies the unexpected
condition. Refer to the Error Code table.
Variable Description
SntpStatus Read-write variable with two choices: enabled and disabled.
TimeZone Read-write variable. Refer to the Time Zone Table for SNMP
fto determine the numerical identifier of the time zone you
wish to set.
PrimaryNTPServerFromDHCP Read-only variable. Displays the primary NTP server
assigned by DHCP, if any.
AlternateNTPServerFromDHCP Read-only variable. Displays the alternate NTP server
assigned by DHCP, if any.
NtpServersSearchOrder Read-write variable with two choices: dhcpFirst and
staticFirst.
StaticPrimaryNTPServer Read-write variable. IP address or name of static primary
NTP server.
Trap File Name Description