Filter
Top Products
Configuring the IN-tact 1101 Configuration Screens
36 Hypercom Corporation
transactions to a processor for troubleshooting purposes or other reasons. All IP addressing
information remains intact. When you are ready to resume sending transactions to a
processor you have disabled, click Enabled to resume normal operation.
4. There are three Connection Types - Standard, HTTP, and Merchant Link. Use the drop-down
list to choose the appropriate type for this host processor, then click Edit at the end of the row.
NOTE: Click Save and Continue or Apply and Restart as appropriate. Keep in mind that your
changes are not written to persistent memory until you click Apply and Restart. Any
changes made on this screen are temporarily saved when you click Edit to access the
next screen. You must still use Apply and Restart in order to write the changes to
persistent memory.
Standard Host Settings Screen
(Used when configuring connections not requiring HTTP protocol)
On the navigation tree, click IN-tact Setup > Application Setup > Host Port. Select Standard
connection type and click Edit.
The IN-tact 1101 uses the addressing information entered here to route transactions to the
appropriate destination. Both a primary and alternate IP address can be configured for each host
processing function. Contact the host processor to obtain the correct IP and port address for
routing if unknown.