Filter
Top Products
System Operations Screen
52 Hypercom Corporation
Restore to Factory Defaults Click to erase the current configuration, any upgraded firmware, and
restore all settings to those as shipped from the factory.
WARNING: Use the previous two options only as the last resort!
Performing these operations erases all IP addresses and other
information and the IN-tact unit will have to be completely
reconfigured before it can process any transactions. If the unit is in a
remote location, it may be necessary to return it to the deployment
center for reconfiguration. Enable DHCP is restored as is the default
IP address of 192.168.1.20.
Enable HLAN Install Mode This is an optional mode of operation used for installation testing of
connected terminals prior to making connections to the host
processor. It allows you to verify the integrity of your HLAN and
terminals before sending any live transactions to the host. Installation
mode should always be disabled before beginning normal operations.
Field/Button Description