Filter
Top Products
Configuring the IN-tact 1101 Configuration Procedure
10 Hypercom Corporation
Materials Required
You will need the following in order to configure the IN-tact 1101:
• A laptop or desktop PC with Internet browser (Microsoft Internet Explorer, version 5.0 or
higher. Other browsers are not currently supported.)
• Two standard Ethernet cables (any length) - one to connect your PC to the hub; the other to
connect the hub to the IN-tact 1101.
• Access to a hub for connections to the PC and IN-tact 1101 unit
• IN-tact 1101 and power supply connected to standard AC power outlet.
Operating System Requirements
Windows 2000 Service Pack 3 or higher should be installed on the computer being used to
configure the IN-tact.
Data Entry - Use of Special Characters
In general, do not use the "double-quote" special character (like the one surrounding the word) in
data entry fields. It is not recognized as a valid character by the IN-tact 1101. The exception to
this is within dial strings. The double-quote character can be used with no problem when being
defined as part of a dial string.
Internet Browser Recommendations
Some browser settings can cause extra system messages to appear and cause other issues.
The following items are suggestions for browser setup while configuring the IN-tact 1101:
• If you use a pop-up blocker, either temporarily disable it or enable it to allow pop-ups from the
IN-tact 1101. Otherwise, pop-up messages from the device may be blocked.
• Enable cookies (no prompt) to avoid numerous browser pop-ups about cookie acceptance
• Active scripting needs to be enabled. By default, active scripting is enabled in Internet
Explorer. You can check or change the setting of this option in Internet Explorer by clicking
Tools > Internet Options > Security tab > Custom Level. Scroll down the list to locate the
Active Scripting option. Click to enable, if it is disabled.
• It is recommended to clear your browser’s cache before configuration or anytime you upgrade
firmware for the device. This is particularly important after a firmware upgrade, as you may not
see the most current Web Server pages unless you clear the browser’s cache.
Configuration Procedure
Use this procedure when you are ready to configure the IN-tact 1101. If you have not already
done so, please read the preceding section before beginning any configuration.
To configure the IN-tact 1101:
1. Connect the IN-tact 1101 to your PC or to a network hub. Use a standard Ethernet cable to
connect the LAN port on the IN-tact 1101 to a hub, or directly to an Ethernet port on the PC