Filter
Top Products
Dial Backup Status
64 Hypercom Corporation
Last Modem Connect Speed The last reported connection speed of the modem. This value is not
reset when you clear statistics for the IN-tact 1101.
Inactivity Timer Disconnects The number of times the modem link was disconnected due to no
transactions or inactivity.
Dial Attempts Total number of dial commands attempted.
Failed Dial Attempts Number of attempted dial commands that failed.
Failed Authentication Attempts Number of PPP negotiations that failed due to an invalid user ID or
password.
Unexpected Disconnects Number of times the link was disconnected due to an unexpected
condition or situation (cable being removed, power outage, etc.).
User Messages In Number of messages received from the host processor via the dial
link. This does not include Ethernet or SNMP traffic.
User Messages Out Number of messages sent to the host processor via the dial link. This
does not include Ethernet or SNMP traffic.
PPP IP Address The IP address assigned to the PPP interface.
Peer IP Address The IP address of the other end of the PPP link.
TABLE 5-1. Status Messages
Status Message SNMP Code Explanation
Dial Backup Feature Not Enabled 0 The feature is disabled by default. Go to the Dial
Backup Settings screen to enable this feature.
Disconnected/Modem Not Present 1 The IN-tact 1101 was not able to detect a modem
attached to the serial port (port 1). Check the
modem cabling and power.
On Hook/Modem Present 2 The IN-tact 1101 was able to detect a modem.
However, the modem is currently not in use.
Dialing/Primary 3 The modem is currently dialing the primary dial
string.
Dialing/Alternate 4 The modem is currently dialing the alternate dial
string.
Negotiating/Primary 5 The modem has successfully connected using the
primary dial string and is negotiating PPP.
Negotiating/Alternate 6 The modem has successfully connected using the
alternate dial string and is negotiating PPP.
Connected/Primary 7 A PPP session has been established using the
primary dial string.
Connected/Alternate 8 A PPP session has been established using the
alternate dial string.
Failure 9 The modem was unable to establish a PPP
connection. Please refer to the primary and
alternate Failure Codes for additional information.
Initializing Modem 10 The modem is being initialized.
Field/Button Description