Filter
Top Products
IN-tact 1101 Software Configuration Guide 11
Configuration Procedure Configuring the IN-tact 1101
(direct connection to the PC requires a crossover Ethernet cable). Connection to a terminal or
terminal network is not required in order to configure the device.
2. Apply power to the IN-tact 1101 and power on your PC. By default, the IN-tact 1101 seeks a
DHCP IP address. Both LEDs on the LAN port will flash in short intervals as the unit seeks a
DHCP IP address. This takes about 15 seconds.
3. On your PC, open the Internet browser (Microsoft Internet Explorer 5.0 or higher).
4. In the browser address bar, type the IN-tact 1101 IP address (either DHCP assigned or the
default static address of 192.168.1.20).
5. Press Enter. The IN-tact 1101 responds with the following message:
6. Click Yes to continue. The Login screen appears.
• If you click No, the Security Alert window closes and the login process is cancelled.
• If you click View Certificate, the Certificate Information window appears.