Hypercom 1101 Network Router User Manual


 
Dial Backup
56 Hypercom Corporation
NOTE: Invoking the primary or alternate dial string causes web and SNMP traffic to use the modem. To
maintain communication with the IN-tact 1101, your web browser or SNMP manager must be
configured to use the IP address of the dial port on the IN-tact device.
Dial and Route Transactions
over Dial Link
Click Dial to immediately dial the alternate processor, establish
connection, and begin routing transactions via the modem.
Disconnect Dial Click to disconnect the modem from either the primary or alternate
host processor as soon as possible. If you are connected to the
IN-tact via PPP (rather than the Ethernet interface) and click this
button, you will be disconnected.
Note: If Disconnect Dial is clicked while in the middle of dialing and/or
establishing a PPP connection, the processing of the disconnect is
delayed until after the dialing and PPP establishment has completed.
Field/Button Description