Filter
Top Products
When a message appears
8
bizhub 160f 8-29
LINE PROBLEM
CHECK LINE
The telephone dialing system
or telephone wiring system
are not set correctly.
Check the telephone dialing
system or telephone wiring
system and use the appro-
priate Utility mode function
to make the correct settings.
The telephone cable is not
attached correctly.
Correctly connect the tele-
phone cable.
*COMM.ERROR*
(####)
Communication is not possi-
ble because of some prob-
lem in the machine.
Check the transmission re-
sults.
Communication is not possi-
ble because of a problem
with the recipient/caller’s fax
machine.
*REDIAL ALL FAILED* All redial attempts failed be-
cause either the recipient’s
line is busy or there was no
answer.
Check the condition of the
recipient’s line, and then try
sending the fax again.
*MEM.FULL/TX CANCEL* While sending a fax, the size
of the data for the scanned
image has exceeded the ca-
pacity of the memory.
Retrieve all received faxes
stored in the memory.
Send the fax by direct trans-
mission.
*MEM.FULL/RX CANCEL* While receiving a fax, the size
of the data for the received
image has exceeded the ca-
pacity of the memory.
Retrieve all received faxes
stored in the memory.
FILE FULL/TX CANCEL While sending a fax, the
maximum of number of man-
aged memory file is used.
Retrieve all received faxes
stored in the memory.
FILE FULL/RX CANCEL While receiving a fax, the
maximum of number of man-
aged memory file is used.
Retrieve all received faxes
stored in the memory.
HANG UP THE PHONE The receiver of the connect-
ed telephone is lifted.
Replace the receiver of the
connected telephone on the
hook.
TEXT ×1.00 1
¦[A]§ #XXX: EMPTY
(While specifying copy set-
tings)
The selected paper tray has
run out of paper.
“#” indicates the paper tray,
and “XXX” indicates the pa-
per size.
Either load paper of the
specified size into the speci-
fied paper tray, or press the
[Paper] key and select a dif-
ferent paper size.
TEXT ×1.00 1
¦[A]§ #XXX: Fax Err
A fax error occurred while an
operation was being per-
formed in Copy mode.
Press the [Fax] key to check
the error condition, and take
appropriate measures.
TEXT ×1.00 1
¦[A]§ #XXX: Comm.Err
A fax transmission error oc-
curred while an operation
was being performed in
Copy mode.
Press the [Fax] key to check
the error condition, and take
appropriate measures.
Message Cause Action
(Flashing alternately)