Filter
Top Products
When a message appears
8
bizhub 160f 8-33
8.11 The machine is not functioning as designed
* If the problem is not corrected even after the operations described are performed, turn off the
machine, unplug its power cord, and then contact the service representative.
Symptom Possible cause Action
Nothing appears in the dis-
play.
Is only the [Start] key lit green? The energy save mode is ena-
bled. Press any key on the
control panel to cancel energy
save mode.
Has the machine been turned
on?
Check that the power cord is
firmly connected and that the |
(on) side of the power switch
has been pressed.
Is the contrast of the display
too light?
From the machine setting
menu of the utility mode, ad-
just the display to the correct
contrast. Refer to “Specifying
LCD CONTRAST” on
page 7-10.
The [Start] key indicator does
not light up green.
The machine has just been
turned on and is warming up.
It takes the machine less than
25 seconds to be ready to
make copies after it has been
turned on.
Please wait.
The machine does not oper-
ate when it is turned on.
The power cord is left un-
plugged.
Plug the power cord into the
power outlet.
The room’s circuit breaker is
open.
Close the room’s circuit
breaker.