Filter
Top Products
Troubleshooting
10-15
10
Responding to an ATTENTION Indicator Flashes
If an ATTENTION indicator flashes, press [Status/Job Cancel] to check an error message. If the message is not
indicated on the Message Display when [Status/Job Cancel] is pressed or the ATTENTION indicator flashes,
check the following.
Symptom Checkpoints Corrective Actions Reference Page
Cannot send fax. Is the modular cord
connected correctly?
Connect the modular
cord correctly.
—
Is Permitted FAX No. or
Permitted ID No.
registered correctly?
Check Permitted FAX
No. and Permitted ID
No..
FAX Operation Guide
Chapter 6 Transmission
Restriction
Has a communication
error occurred?
Check error codes in the
TX/RX Result Report
and Activity Report. If
the error code starts with
"U" or "E", perform the
corresponding
procedure.
FAX Operation Guide
Appendix
"Error Code List"
Is the destination FAX
line busy?
Send again. —
Does the destination
FAX machine respond?
Send again. —
Is there an error other
than above?
Contact your Service
Representative.
—