Filter
Top Products
Repair Information 4-23
5055-01x
Gear Cover Removal
Multi-Purpose Feeder Roll Removal
Multi-Purpose Feeder Clutch Removal
OHP Detection Sensor (Upper) Removal
1. Open the top unit, and remove the upper cassette, front cover,
multi-purpose feeder, right side cover, and turn guide.
2. Remove the two screws from the gear cover, and remove the
cover.
3. Remove the four screws from the multi-purpose feeder frame
and the ground board screw.
4. Disconnect the connector of the multi-purpose feeder paper
feed sensor.
5. Pull out the multi-purpose feeder frame slightly.
Service.bk Page 23 Thursday, October 4, 2001 12:20 PM