Filter
Top Products
4-48 Service Manual
5055-01x
Paper Size Sensor Board Assembly Removal
1. Open the top unit and remove the RIP cover, RIP board, RIP
box, and electronic box. Remove the upper cassette, front cover
B, and back cover. Open the turn guide and paper feed cover
and remove the duplex unit. Remove the left side cover and
power supply A.
2. Disconnect the connector and remove the two screws from the
paper size sensor board, removing the board.
3. Remove the screw from the size detection lever, and remove the
lever.
Service.bk Page 48 Thursday, October 4, 2001 12:20 PM