Filter
Top Products
Repair Information 4-13
4085-001
Ink Levels and Temperature Sensor with Bracket
Removal
1. Remove the rear cover. Refer to “Rear Cover Removal” on
page 4-3.
2. Remove the operator panel cover. Refer to “Operator Panel
Cover/Operator Panel Removal” on page 4-5.
3. Disconnect the ink level and temperature sensor connector
(J12) on the engine board. Note the wire routing.
4. Remove the right cover.
5. Remove the screw {A} from the sensor bracket.
6. Remove the sensor and bracket {B}.