Filter
Top Products
4-48 Service Manual
4085-001
Backup Roller Spring Removal
1. Lift the front door on the printer.
2. Press the coil on the backup roller spring to center and remove.
Note the position of the spring before removing.
Carrier/Cable Retainer Removal
1. Remove all covers.
2. Remove the engine board cover.
3. Disconnect carrier cables from the engine board.
4. Remove the carrier guide shaft from the carrier.
5. Unlatch the cable restraint, disconnect carrier cables from the
rear of the carrier and remove.
6. Depress the retainer cable clip, move the cable to the right and
remove.