Filter
Top Products
4-26 Service Manual
4085-001
PerfectFinish Sensor Assembly/Rear Paper Path
Sensor Removal
1. Remove the rear cover. Refer to “Rear Cover Removal” on
page 4-3.
2. Remove the power supply. Refer to “Power Supply Removal” on
page 4-19.
3. Remove the RIP-EMC shield assembly and RIP card. Refer to
“RIP-EMC Shield Assembly/RIP Card Removal” on page 4-24.
4. Disconnect the wire from the PerfectFinish sensor.
5. Remove two screws from the PerfectFinish sensor.
6. Remove the PerfectFinish sensor.
7. Remove the PerfectFinish tank.
8. Remove two screws and remove the PerfectFinish cartridge.
9. Unsnap the rear paper path sensor arm and remove. Note the
position of the spring.
10. Lift the left side, unlatch the paper path sensor.
11. Disconnect the wire from paper path sensor.
12. Remove the paper path sensor.