Filter
Top Products
6-2 Service Manual
4085-001
• Avoid oil contact with the outer pulley surface and flanges
that contact the belt.
Motor Pulley Studs
• Apply Shell Tellus #100 oil to the idler stud and compound
pulley stud {8}. The amount of Shell Tellus #100 to be used
should be visible on the stud but not dripping or running onto
the motor bracket, pulleys or frame. For reference, use
approximately 0.005 grams on the compound pulley stud
and approximately 0.003 grams on the idler pulley stud.
Carrier Latch Camshaft Lubrication
• With the carrier handle raised to disengage the camshaft,
apply small drops of Nye Uniflor 8512 (0.01 grams to 0.02
grams per cam) to the carrier backup bracket in the regions
directly behind the camshaft lobes.
• Open and close the handle a couple of times to ensure that
the contacting surfaces of the cams and bracket have been
lubricated.
• If appropriate, remove any excess lubricant from the bracket
around these regions, being careful to avoid contamination
of the carrier card or carrier cables. Lubricant should not drip
down the carrier card bracket.
Carrier Card Pogo Pins
• Use Nye Tact 570H-10 to lubricate the ink tank pogo pins on
the carrier card assembly. Use of an appropriate fixture is
needed to properly lubricate the ink tank pogo pins. For
reference, this amount should be about 0.05 grams wet.
• Shake well before applying Nyetact 570H-10 lubricant.
Depress the applicator bottle on each set of pogo pins only
once, avoiding excessive drippage on other parts of the
carrier card.