Line 6 GearBox 3.7 – GearBox with POD X3
5•6
Monitor knob• - Attenuates the overall level of the Studio/Direct Mix heard via POD X3 (i.e.
USB Hardware Monitoring). This affects the Monitor level of both Tones 1 & 2. (Note that
this knob does not affect what is fed to Sends 1 & 2 and, therefore, will not affect the recording
levels in your audio software). Use this knob to balance out how loud your instrument is versus
playback audio tracks from your computer, without affecting your recording level.
12 - 1/4-Inch Output options: Choose from three “Studio/Direct Mix” Modes (for direct connections
to a mixer, recorder, PA, or headphones) or four “Live” Modes (for feeding a guitar amp, without
speaker/mic/room simulation, and with a set of controls for on/mute and pan for Tone 1 and Tone 2
that is independent from the Studio/Direct Mix settings).
1/4 Inch Outputs menu
Studio Modes:
Match Studio/Direct • – the 1/4-inch jacks output the same Studio/Direct Mode Mix as is set on
the GearBox Studio Direct Mix controls above.
Studio/Direct Tone 1• – the 1/4-inch jacks output Tone 1 only, panned center, with Studio Mode
processing.
Studio/Direct Tone 2• – the 1/4-inch jacks output Tone 2 only, panned center, with Studio Mode
processing.
Live Modes:
Combo Front• – use this to jack into the instrument input of a combo guitar amp.
Combo Power Amp• – use this to jack into the power amp input of a combo guitar amp.
Stack Front• – use this to jack into the instrument input of a guitar amp head with separate cab.
Stack Power Amp• – use this to jack into the power amp input (or the effect loop “return” jack,
if your amp has one) of a guitar amp head with separate cab.
Live Mode Tone Mute & Pan controls - When any of the above Live Mode options are selected,
you’ll see an additional set of controls appear here. The Tone buttons and Pan sliders allow you to
Mute and Pan each Tone individually as it is fed out the 1/4 Inch Outputs of your POD X3 (or the
Live Out jacks of a POD X3 Live or Pro). Note that these Mute and Pan settings are independent of
what is fed to the Studio/Direct Mix, allowing you to feed a different signal to your amp while the
Studio/Direct Mix is fed to your Record Sends (and to the XLR Direct Outs of a POD X3 Live)...