Filter
Top Products
5
5.5 Administrator Mode Operations
5-58 CF2002/CF3102
Utility Mode Operations Chapter 5
To set the “Stabilizer” function (if the image is still incorrect, even after the
gradation levels have been adjusted)
If the image is incorrect, even after the gradation levels have been adjusted, set the
“Stabilizer” function.
The following two modes are available with the “Stabilizer” function.
●
Reset And Stabilizer Mode
●
Stabilizer Mode
The “Stabilizer” function performs an image stabilization based on past data up to
the previous session.
Image stabilization should normally be performed with “Stabilizer Mode” selected.
Select “Reset And Stabilizer Mode” only if the desired effect cannot be attained with
the “Stabilizer Mode”.
1
Press the [Utility] key.
2
Touch [Admin. Mode].
3
Using the keypad, enter the administrator access code.
4
Touch [Expert Mode].
5
Touch [Stabilizer].
6
Press the [Start] key.
The indicator on the
[Start] key changes to
orange, and the image
stabilization operation
is performed.
The indicator on the
[Start] key changes
back to green.
The image stabilization
procedure is finished.