Filter
Top Products
3300 ICP Hardware User Guide
114 Release 3.3
System Installation Overview
To install your 3300 ICP system:
1. Install the 3300 ICP Controller
2. Configure the Controller
3. Install the Universal NSU
4. Install the R2 NSU
5. Install the BRI NSU
6. Install the Universal ASU
7. Install the ASU
8. Install the Peripheral Unit
9. Install the SUPERSET HUB
10. Install the Digital Service Unit
11. Install Wireless Devices
12. Connect the Controller to the LAN
13. Launch the System Administration Tool to program the system. (Refer to Overview of
Programming).
Installation Planner
The following required and default settings are necessary for an installation:
Tip: You can complete all of the programming without having physical connections to
the Controller. After programming you can connect units to the controller and then
power-up the system.
System Administration Tool
username (Default = system)
password (Default = password)
Controller Configuration (RTC)
Default Settings
Settings to
Change
boot device ata=0,0
processor number 0
host name
file name /sysro/RTC8260
inet on ethernet (e) 192.168.1.2 IP address: subnet mask
inet on backplane (b)
host inet (h) IP address of the ftp server
gateway inet (g) Default Gateway
user (u) ftp FTP user (installer's PC)
ftp password (pw) @ FTP password (installer's PC)