Filter
Top Products
3300 ICP Hardware User Guide
122 Release 3.3
Install the System ID Module
The system ID module is shipped with the software. You must install the system ID module in
the 3300 ICP controller. The module contains a unique identifier that the system reads on
start-up.
250 / 700 User Controller
To install the System ID Module:
1. Remove the cover.
2. Press firmly to seat the module on the board. In the 250 user and 700 user controllers,
placement of the System ID Module is between Slot 1 (the Dual FIM) and Slot 8 (the DSP).
The module will cover the 'MMC 8' text printed on the board.
3. Replace the cover.
100 User Controller
To install the System ID Module:
1. Remove the cover.
2. Press firmly to seat the module on the board. In the 100 user controller, placement is
behind Slot 2.
3. Replace the cover.