Mitel 3300 Network Hardware User Manual


 
Install Upgrades and FRUs
Release 3.3 195
SX-2000 MICRO LIGHT to 3300 ICP
To upgrade SX-2000 MICRO LIGHT hardware for 3300 control:
Replace the Main Controller in the MICRO LIGHT with a Triple FIM Card.
If existing capacity is greater than that of the 3300 ICP, the conversion may fail. See the
capacity table for the 3300 ICP.
By installing a triple FIM card in the SX-2000 MICRO LIGHT main cabinet, you can physically
connect it to the 3300 ICP by using multi-mode fiber. As a result, you can use the existing
peripheral and digital trunk cards within the main cabinet. Connect any external cabinets by
using FIMs.
3200 ICP to 3300 ICP
To upgrade 3200 ICP hardware for 3300 ICP control:
If existing capacity is greater than that of the 3300 ICP, the conversion may fail. See the
capacity table for the 3300 ICP.
The 3200 ICP database is converted and restored to a 3300 ICP database, and any peripheral
cabinets connected to the FIM ports on the 3300 Controller.
In addition to the DNIC telephones supported by the peripheral cabinet, the 3300 ICP supports
the following legacy IP telephones:
SUPERSET 4015IP
SUPERSET 4025IP.
Software
Software Upgrade Procedure (3.2 to 3.3)
This procedure installs new software on your 3300 Controller to upgrade from 3300 ICP 3.0,
3.1, or 3.2 to 3.3 software.
A similar Software Install Procedure can be used to rebuild or replace a corrupted 3.3 database.
For this procedure, see the 3300 ICP Technician’s Handbook or the System Administration
Tool Help.
WARNING: The software upgrade procedure will format the 3300 Controller hard drive
and install new software.