Mitel 3300 Network Hardware User Manual


 
3300 ICP Hardware User Guide
120 Release 3.3
Install the 3300 Controller
To install the 3300 Controller:
1. Install the Hard Drive.
2. Install the System ID Module.
3. Install any DSP Modules.
4. Connect power to the Controller.
5. Set up a serial connection between the 3300 Configuration Tool PC and the Maintenance
(RS-232) port on the 3300 Controller. Baud rate - 9600, Data bits - 8, Parity - None, Stop
bits - 1, Flow control - None.
6. Set up an Ethernet connection between the 3300 Controller and the 3300 Configuration
Tool PC (a standard LAN cable from an RJ-45 connector on the 3300 Controller L2 switch
to the PC NIC).
250 / 700 User Controller
Note: You can connect IP telephones to the 3300 Controller through L2 switch external
ports on the 250 User and 700 User Controllers, for testing only, after installation of the
database and configuration. IP Phones require a configured DHCP server.