Filter
Top Products
3300 ICP Hardware User Guide
136 Release 3.3
3. Complete telephony cabling.
4. Complete programming.
5. Connect power to the 3300 Universal ASU. CIM LEDs will be on once the CIM link syn-
chronizes. The 3300 Controller will detect the 3300 Universal ASU, and the application
software will download and start immediately.
Install the 3300 ASU
Before you begin, ensure there is a free CIM port on the 3300 Controller.
To install the 3300 ASU:
1. Mount the 3300 ASU in the 19-inch rack (if applicable).
2. Connect the supplied cross-over Category 5 cable with RJ-45 connector to the CIM port
on the 3300 ASU and a free CIM port on the 3300 Controller. Up to four ASUs can be
connected to a 3300 Controller.
3. Complete telephony cabling.
4. Complete programming.
5. Connect power to the 3300 ASU. CIM LEDs will be on once the CIM link synchronizes.
The 3300 Controller will detect the 3300 ASU, and the application software will download
and start immediately.
Install the Peripheral Unit
Overview of the Peripheral Unit Installation
To install a Peripheral Unit:
1. Unpack, position, and ground the Peripheral Unit.
2. Check the card layout.
3. Connect the fiber cable to the node.
4. Check the grounding.
5. Install the power converter.
6. Install the Peripheral Interface cards.
7. Cable the node to the MDF.
8. Power up the Peripheral Unit.
Once you have completed these steps, you can proceed to Installing a DSU Node, Installing a
SUPERSET HUB, or return to System Installation Overview.
Note: For information about removing and replacing the front panel of the cabinet, see
Front Panels in the Install Upgrades and FRUs section.