Filter
Top Products
172
*1 When outside the setting range, a write data error (error code: 4
H
) occurs.
The Q64TCN automatically sets optimum PID constants if the following functions are used.
• Auto tuning function ( Page 176, Section 4.6)
• Self-tuning function ( Page 223, Section 4.18)
CH Control
output cycle
setting
Un\G47 Un\G79 Un\G111 Un\G143
The setting
is ignored.
*1
1 to 100 (1s to 100s)
Page 114,
Section
3.4.2 (23)
CH Heating
control output
cycle setting
Un\G47 Un\G79 Un\G111 Un\G143
CH Cooling
control output
cycle setting
Un\G722 Un\G738 Un\G754 Un\G770
CH
Overlap/dead
band setting
Un\G723 Un\G739 Un\G755 Un\G771
Configure the setting in the range from -100 to 100 (-
10.0% to 10.0%) toward the full scale of the set input
range.
Page 152,
Section
3.4.2 (74)
CH Manual
reset amount
setting
Un\G724 Un\G740 Un\G756 Un\G772
The setting
is ignored.
*1
Configure the
setting in the range
from -1000 to 1000
(-100.0 to 100.0%)
toward the full scale
of the set input
range.
The setting is
ignored.
*1
Page 152,
Section
3.4.2 (75)
Buffer
memory area
name
Buffer memory address Setting range
Reference
CH1 CH2 CH3 CH4
Two-
position
control
P
control
PD
control
PI
control
PID
control