Filter
Top Products
135
CHAPTER 3 SPECIFICATIONS
3
3.4 Buffer Memory Assignment
3.4.2 Details of the buffer memory
(49)Cold junction temperature compensation selection (Un\G182)
Select whether to perform the cold junction temperature compensation using a standard terminal block or not to
perform the cold junction temperature compensation.
(a) Supported modules
• Q64TCTTN
• Q64TCTTBWN
(b) Setting range
• 0: Use Standard Terminal Block
• 1: This setting cannot be used.
• 2: Not used the cold junction temperature compensation
(c) Default value
The default value is set to Use Standard Terminal Block (0).
(50)Control switching monitor (Un\G183)
The setting contents of the control mode selection set on Switch Setting are stored in this buffer memory area.
The control mode in operation can be confirmed.
The stored values and the contents are shown as below.
• 0: Standard control
• 1: Heating-cooling control (normal mode)
• 2: Heating-cooling control (expanded mode)
• 3: Mix control (normal mode)
• 4: Mix control (expanded mode)
Select the control mode on Switch Setting.
For details on the setting method, refer to the following.
Page 299, Section 6.2
For details on the control mode, refer to the following.
Page 162, Section 4.1
Common
Common