Filter
Top Products
9 - 9
9.2 Requirement to Conform to the Low Voltage Directive
9.2.1 Standard applied for MELSEC-QS series programmable controller
9
EMC, LOW VOLTAGE, AND MACHINERY DIRECTIVES
9.2 Requirement to Conform to the Low Voltage Directive
The Low Voltage Directive requires each device that operates with the power supply
ranging from 50 to 1000VAC and 75 to 1500VDC to satisfy the safety requirements.
In Section 9.2.1 to Section 9.2.5, cautions on installation and wiring of the MELSEC-QS
series programmable controller to conform to the Low Voltage Directive are described.
These descriptions are based on the requirements and standards of the regulation,
however, it does not guarantee that the entire machinery manufactured based on the
descriptions conforms to the above-mentioned directive. The method and judgment for the
conformity to the low voltage directive must be left to the manufacturer's own discretion.
9.2.1 Standard applied for MELSEC-QS series programmable controller
The standard applied for MELSEC-QS series programmable controller is EN61131-2
safety of devices used in measurement rooms, control rooms, or laboratories.
The MELSEC-QS series programmable controller modules which operate at the rated
voltage of 50VAC/75VDC or above are also developed to conform to the above standard.
The modules which operate at the rated voltage of less than 50VAC/75VDC are out of the
Low Voltage Directive application range.
For CE-marked products, please consult your local Mitsubishi representative.
9.2.2 MELSEC-QS series programmable controller selection
(1) Power supply module
There are dangerous voltages (voltages higher than 42.4V peak) inside the power
supply modules of the 100/200VAC rated input voltages. Therefore, the CE marked
models are enhanced in insulation internally between the primary and secondary.
(2) CPU module, base unit
Using 5VDC circuits inside, CPU modules and base units are out of the Low Voltage
Directive application range.
(3) Intelligent function module
The intelligent function module is out of the scope of the Low Voltage Directive
because the rated voltage is 24VDC or less.