Panasonic AJ-B95 Laptop User Manual


 
OPERATION menu
The underlining indicates the factory setting.
170 HUMID OPE
0000
0001
OFF
ON
This selects whether the unit is to continue operating when
condensation has formed.
0: The unit does not operate.
1: It operates even when condensation has formed but no
guarantees are made for its operation.
<Note>
Since tape damage or other problems may occur when 1: ON
has been selected, the 0: OFF setting should normally be used.
171 ALL STOP SEL
0000
0001
STOP
STILL
This selects the units mode to be established when the ALL
STOP button has been pressed.
0: The unit is set to the STOP mode.
1: The unit is set to the still-picture (SHTL + 0.0, JOG STILL)
mode.
[
[
110 MEMORY STOP
0000
0001
OFF
ON
This selects the processing to be conducted when the counter
displays zeros in the CTL mode or during FF or REW.
0: The VTR is not shut down.
1: The VTR is automatically shut down.
<Note>
O
For the stop mode, either the stop or still-picture (SHTL + 0.0,
JOG STILL) mode is set depending on the setup menu item
No.315 (AFTER CUE-UP) setting.
O
When both the AUTO REW function and MEMORY function
have been selected, the AUTO REW function takes priority.
[[
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
V
T
R
1
V
T
R
2
172 VTR1 IN SEL
0000
0001
V1 IN
V2 IN
This selects the VIDEO/AUDIO input of VTR1 when the analog
signal input has been selected.
0: VTR1 IN serves as the VTR1 input.
1: VIDEO IN and AUDIO IN of VTR2 serve as the VTR1 input.
<Notes>
O
The unit will not operate when SDI signal input has been
selected.
O
This operation is not performed in the 625i mode.
[
173 BATTERY SEL
0000
0001
0002
0003
0004
0005
0006
0007
0008
10.8V
11.0V
11.2V
11.4V
11.6V
11.8V
12.0V
12.5V
13.0V
This selects the voltage threshold for warning when the DC supply
voltage has dropped.
(The units power is automatically turned off when it drops to 10.6
V.)
0: When it has dropped to 10.8 V
1: When it has dropped to 11.0 V
2: When it has dropped to 11.2 V
3: When it has dropped to 11.4 V
4: When it has dropped to 11.6 V
5: When it has dropped to 11.8 V
6: When it has dropped to 12.0 V
7: When it has dropped to 12.5 V
8: When it has dropped to 13.0 V
[
174 SDI OUT
0000
0001
VTR1
VTR2
This selects the SDI output.
0: The VTR1s signals are output.
1: The VTR2s signals are output.
[
34
Setup menus