57
Cut editing operations
Storing the edit points
Select the VTR whose edit points are to be set
using the VTR1 button or VTR2 button.
There are three main ways to store edit points.
2
Use the search dial to search the edit point in the
shuttle mode or jog mode.
3
Temporarily stop the tape at the edit point, and
press the MARK IN button or MARK OUT button.
This sets the edit IN point or OUT point.
1
1. Use the search dial to search the
editing screen, and set the edit point
using the MARK IN or MARK OUT
button.
Select the VTR whose edit points are to be set
using the VTR1 button or VTR2 button.
2
Press the IN button or the OUT button.
3
Input the desired time code value as a numeric
value.
(Press “83209” if this is 8 minutes 32 seconds 09
frames.)
4
The input value is entered when the ENTER button
is pressed.
1
2. Use the numeric input buttons to input
the time codes of the edit points
directly.
Select the VTR whose edit points are to be set
using the VTR1 button or VTR2 button.
2
After setting the edit IN point, press the DUR
button.
3
Input the desired editing period length (duration) as
a numeric value.
(Press “2607” if this is 26 seconds 07 frames.)
4
The input value is entered when the ENTER button
is pressed.
<Notes>
O
The set edit points are indicated by the edit point
setting display lamps (IN lamp and OUT lamp).
O
If three of the four points—the IN point and OUT
point for VTR1 and the IN point and OUT point for
VTR2—are set, the edit point setting procedure is
completed.
The remaining point will be automatically calculated
when editing is performed.
1
3. Specify and set the length (duration of
the editing period).