69
Checking the edit points
(IN, OUT, DUR, GO TO)
$
Checking the edit IN point setting (IN)
Press the IN button.
While holding down this button, the VTR1 IN point
data is shown on the VTR1 counter, and the VTR2
IN point data is shown on the VTR2 counter.
$
Checking the edit OUT point setting
(OUT)
Press the OUT button.
While holding down this button, the VTR1 OUT
point data is shown on the VTR1 counter, and the
VTR2 OUT point data is shown on the VTR2
counter.
$
Checking the editing duration setting
(DUR)
Press the DUR button.
While holding down this button, the editing duration
of the event displayed is shown on the VTR1 and
VTR2 counters.
$
Edit point cue-up (GO TO, GO TO OUT)
Press the GO TO button after selecting the VTR
using the VTR1 or VTR2 button.
The lamp above the GO TO button now lights, and
the selected VTR automatically searches for the
edit IN point, and stops.
If the GO TO OUT ([SHIFT] + [GO TO]) button is
pressed instead of the GO TO button, the selected
VTR automatically searches the edit OUT point,
and stops.
$
Cue-up to a specific time code (GO TO)
Select the VTR using the VTR1 or VTR2 button.
After inputting the specific time code value or CTL
value using the numeric input buttons, press the
GO TO button. The lamp above the GO TO button
now lights, and the selected VTR automatically
searches the time code which was input, and stops.
