Filter
Top Products
COMSPHERE 6800 Series Network Management System
4-50 January 1997 6800-A2-GN22-30
Analysis Network Management System
This section explains how to connect the Paradyne ANALYSIS Network Management System to
the host processor. This feature is only supported on the Altos 5000 platform.
An IPC-900 card installed in the host processor provides the cut-through access to the ANALYSIS
NMS. This is a dedicated IPC-900 card that is installed solely for ANALYSIS purposes. It has
eight user-configurable ports. Port 1 is used to connect to the first ANALYSIS NMS. This port will
handle alerts, cut-throughs, printer assignments and upload of device information. The other seven
ports on the IPC card are available for connection to up to five other ANALYSIS Network
Management Systems.
You can connect the ANALYSIS NMS either locally or remotely. The following sections explain.
NOTE
The port configuration on the ANALYSIS NMS must also be defined.
This is done on the ANALYSIS NMS and is not discussed in this
document. For more information, see the
ANALYSIS 6510
Automated Network Management System Reference Manual
. The
ANALYSIS software must be Version 6.1. In addition, the NMS
software must be activated and the ANALYSIS NMS must be
configured into the system. Instructions for both these tasks can be
found in Chapter 5,
Loading and Restoring Software
.
Connecting Locally
To connect a local ANALYSIS NMS to the host processor, you will need the following materials:
• 035-0153-0031 cable
• 002-0040-0031 connector (for ANALYSIS 6510/5605)
• A 002-0053-0031 connector (for ANALYSIS 5600)
Figure 4-25 illustrates a local connection for both the ANALYSIS 6510/5605 and ANALYSIS
5600 NMS. The following sections explain how to connect both systems locally.