Filter
Top Products
Preparing the Processors
2-516800-A2-GN22-30 January 1997
Full-Feature Workstation
Preinstallation Checks for the EtherLink II Card
The 3COM EtherLink II Card is installed at the factory for workstations from Paradyne but the
user should check that the settings on the card are properly configured.
1. Check the jumper settings on the EtherLink II card (see Figure 2-27). Confirm that:
a. The I/O Base Address jumper at J3 is set to 300.
b. The Memory Address jumper at J3 is set to C8000.
c. The Data Mode jumper at J5 is set to 16 bit transmission.
2. Be sure that the EtherLink II card is properly seated.
300
310
330
350
250
280
2A0
2E0
I/O BASE
DISABLE
C8000
CC000
D8000
DC000
MEMORY
J3
J5
816
DATA MODE
493-14256
Figure 2-27. EtherLink II Card Jumper Settings