Filter
Top Products
Preparing the Printers
3-96800-A2-GN22-30 January 1997
Fujitsu DL3600
The Fujitsu DL3600 is a multicolor, 24-pin dot matrix printer. The printer communicates with the
host processor through a parallel (Centronics) interface; the interface receptacle is positioned at the
right rear corner of the printer.
Modifying the default printer settings requires use of the front control panel buttons. This panel is
shown in Figure 3-4.
To modify the default settings, perform the following steps:
1. Connect the power cable to the printer and plug the power cable into an outlet. DO NOT
SWITCH ON THE POWER YET. Load continuous form paper into the printer. (For
detailed instructions, consult the Fujitsu DL3600 User’s and Programmer’s Manual that
comes with the printer.)
2. Put the printer in SETUP mode by pressing and holding down the MODE button and
switching the printer’s power on. The SETUP mode menu will be printed as shown in
Figure 3-5. To view the menu fully, pull the clear plastic cover over the roller completely
forward.
3. SETUP mode consists of a number of functions. The first function, MENU1, consists of 21
individual printer settings. These settings along with their correct values are specified in
Table 3-1.
The red cursor on the plastic print guide is positioned under the current function. Other
functions may be selected by repeatedly pressing the MODE button. To begin changing the
settings of a particular function, press the FF button.
Select the MENU1 function by pressing the MODE button until the red cursor is
positioned under the printed MENU1 tag.
Figure 3-4. DL3600 — Front Control Panel