Filter
Top Products
Preparing the Printers
3-56800-A2-GN22-30 January 1997
Fujitsu DL3400
The Fujitsu DL3400 is a multicolor, 24-pin dot matrix printer. This printer communicates with the
host processor through a parallel (Centronics) interface. The interface cable receptacle is
positioned at the right rear corner of the printer.
To modify the default settings, you use the buttons on the front control panel. This panel is shown
in Figure 3-2.
To modify the default settings, perform the following steps:
1. Connect the power cable to the printer and plug the power cable into an outlet — but do
not turn the power on yet. Load 13.5 inch-wide continuous form paper into the printer. (For
detailed instructions, consult the Fujitsu DL3300/3400 Printer User’s Manual that comes
with the machine.)
2. To modify the printer’s default settings, you must be in SETUP mode. To put the printer in
SETUP mode, press the MODE button on the front control panel and — while continuing
to hold the MODE button down — turn the printer’s power on.
The MODE indicator on the front panel will light, and the SETUP mode opening menu
will be printed. This menu is shown in Figure 3-3 (to view the menu, pull the clear plastic
front cover completely forward).
3. SETUP mode consists of a number of functions. The first function is referred to as
MENU1. To access this function, press the MODE button until the cursor is positioned
next to MENU1.
The MENU1 function consists of 22 individual printer settings. These settings are shown
below, along with the correct value for each setting.
FF
LETTER
FONT1
MENU1
LF
DRAFT
FONT2
MENU2
MODE
ONLINE
POWER
PAPER OUT
Pushbuttons
POWER On Indicator
Status Indicators
492-12819-0
2
Figure 3-2. DL3400 — Front Control Panel