Filter
Top Products
COMSPHERE 6800 Series Network Management System
6-8 January 1997 6800-A2-GN22-30
Starting UNIX on the UIP
To start the UNIX operating system, perform the following steps.
1. With the RESET key in the RUN position, turn on the power switch on the System 5000.
The UNIX system will proceed to boot, and as it boots it will display a series of
self-check and diagnostic messages on the console screen. After these messages have
displayed, the following message displays:
Type CONTROL-d to proceed with normal start-up
(or hit return for system maintenance):
2. To select normal start-up, press the Ctrl and d keys simultaneously.
3. The boot process will continue. When the system has fully booted, the login prompt
displays on your screen.
Starting the UIP Application Program
Once UNIX has been started, you can start the UIP application program. To do so, perform the
following steps:
1. At the login prompt:
TYPE: uip
PRESS: Enter
2. In response, the password prompt displays.
TYPE: the UIP password (the default UIP password is startmenu)
PRESS: Enter
The Network Management System Menu displays (Figure 6-5).
494-13959-0
1
Network Management System
Select:
1) Start the system
2) Stop the system
3) Shutdown UNIX
4) Install PTF
5) Return to Console login
Enter number [1,2,3,4,5]:
Figure 6-5. Network Management System Menu