Filter
Top Products
COMSPHERE 6800 Series Network Management System
3-4 January 1997 6800-A2-GN22-30
5. When you have changed all necessary MENU1 settings, you are ready to access the second
SETUP function — HARDWARE. To do this, press the FF button again. The message
HARDWARE
will appear in the display area. The HARDWARE function consists of 13 individual printer
settings. These settings are shown below, along with the correct value for each setting (only
eight of the settings apply to a parallel connection).
SETTING SERIAL PARALLEL
SPEED :NORMAL :NORMAL
PPR-OUT :DETECT :DETECT
PRT-DIR :BI-DIR :BI-DIR
BUZZER :ON :ON
WORD-LG :8 BIT :8 BIT
BUFFER :8KBYTE :8KBYTE
FEEDER :NONE :NONE
INTRFCE :SERIAL :PARALLEL
FORMAT :8NONE 1
BAUD-RT :9600
PROTOCOL :XON/XOF
DSR :IGNORE
DUPLEX :FULL
6. Follow the procedure described in Step 4 to scroll through the HARDWARE settings and
compare them to the correct settings shown above. If any of the settings are incorrect,
follow the procedure in Step 4 to change them.
7. Once the MENU1 and HARDWARE settings are correct, you must save them (if you do
not save them, your selections will be lost when the printer’s power is turned off). To do
this, press the FF button until the message
FUNCTN:SAVE
appears in the display area. Then press the RESET button. The message
SAVING NOW!!
will appear, followed by the message
FUNCTN:SAVE
8. The modified settings have now been saved in the printer’s memory. Press the ONLINE
button to return the printer to the ONLINE mode. The message
ONLINE:READY
will appear in the display area.