Filter
Top Products
Loading and Restoring Software
5-76800-A2-GN22-30 January 1997
NOTE
If the system fails to respond to keystrokes at any point during the
installation procedure, it is necessary to power down the processor,
wait approximately 60 seconds, power up the processor, and
resume the installation at the point you left off.
When you have these items, perform the following steps:
1. Insert the Volume 1 diskette in the floppy disk drive. Turn on the processor and make sure
the RESET key is in the RUN position.
The processor begins the boot process and runs through its internal memory checks.
When booting a System 15000, several status messages appear, ending with a BOOT:
prompt. Proceed to Step 4.
When booting a System 5000, the following message appears:
Press space bar to interrupt autoboot
NOTE
If an error message about memory appears, ignore it and continue
the procedure.
2. PRESS: the spacebar immediately
and the menu in Figure 5-2 appears:
NOTE
If this menu does not appear, you missed the time-out window. You
will need to restart the procedure.
492-1395
4
Select [1] to boot from Hard Disk
Select [2] to boot from Floppy
Select [3] to boot from Tape
Select [4] to enter BIOS setup
Enter Option:
Figure 5-2. System 5000 Boot Menu (Installing UNIX on Host Computer)