Filter
Top Products
COMSPHERE 6800 Series Network Management System
2-38 January 1997 6800-A2-GN22-30
Installing the Second and Third Hard Disks in the System 15000
To physically install the second and third hard disks in the System 15000 chassis, refer to
Figure 2-20 and perform the following steps for each disk:
1. Attach the 3.5I mounting brackets to the side of the disk.
2. Slide the drive into the chassis and attach the SCSI bus ribbon cable using the next
connector available on the cable to the 50-pin connector on the drive.
3. Attach the power connector to the 4-pin connector on the drive.
4. Push the drive into the chassis until it is fully seated and the mounting brackets lock in the
chassis.
494-14509-0
1
3rd Hard
Drive
2nd Hard
Drive
1st Hard
Drive
Figure 2-20. Altos 15000 Showing the Hard Disk Bay