Filter
Top Products
COMSPHERE 6800 Series Network Management System
8-12 January 1997 6800-A2-GN22-30
14. Power down the processor and remove the IPC-1600 card. Reset the memory address
from A0000 to its original setting as shown in Figure 2-14 for an Altos 5000 or Table 2-6
for an Altos 15000. Replace the card and power-up the processor.
Emulex DCP-286i Diagnostic Program
(for Altos 5000 Systems Only)
To run the diagnostic program that comes with the Emulex DCP-286i card, you need the disk
entitled DCP286i Diag Disk Rev A that is shipped with the card and a bootable MS-DOS disk.
With these items, perform the following steps:
1. Move the RESET/RUN key on the front panel clockwise to the RUN position to reboot
the System 5000 (if the System 5000 is turned off at this point, move the power switch on
the rear panel to the ON position instead). The System 5000 will run through its normal
power-up sequence and display the following message:
Press spacebar to interrupt autoboot
2. PRESS: the spacebar immediately
The Boot Menu displays (see Figure 8-1).
3. Insert the bootable MS-DOS disk into disk drive and select Option 2 to boot from the
floppy.
4. Once the System 5000 has booted, insert the disk entitled DCP286i Diag Disk Rev A into
the disk drive and
TYPE: DCPDIAG2
PRESS: Enter
The diagnostic’s Main Menu displays, with the highlight positioned on the option Run.
5. To run the program,
PRESS: Enter
When the program finishes, the system returns to the Main Menu.
6. To exit the program and return to MS-DOS, highlight Exit and
PRESS: Enter