Filter
Top Products
Loading and Restoring Software
5-96800-A2-GN22-30 January 1997
494-13956-0
2
Please specify Hardware Configuration:
1. Hardware configuration I (Single hard disk - UIP)
2. Hardware configuration II (Two or more hard disks - NMS HOST)
3. Exit Installation
Please enter your choice [1-3]:
Figure 5-4. Hardware Configuration Menu (Installing UNIX on Host Computer)
6. To proceed,
TYPE: 1
PRESS: Enter
The menu in Figure 5-4 appears (on a 5000 platform, Item 2. reads as follows:
Hardware Configuration II (two hard disks — NMS Host):
7. For the host computer,
TYPE: 2
PRESS: Enter
If you are loading an Altos System 15000, the system prompts:
Enter the SCSI Host Adapter number of the hard disk [0–1] or type \‘q’ to quit:
TYPE: 0
PRESS: Enter
On both 5000 and 15000 platforms, the system sets the operating system environment,
configures the hard disk, creates a UNIX partition, and divides the partition into file
systems and swap space. These processes take about fifteen minutes.
When this is complete, the following message appears:
Altos UNIX System V Operating System Serialization
When prompted, use the seral number and activation key included with the
Altos System V Operating System distribution
Enter your serial number or enter q to quit:
TYPE: the UNIX serial number (found on the Serial Number card attached to the Release
Notes)
PRESS: Enter