Filter
Top Products
COMSPHERE 6800 Series Network Management System
2-50 January 1997 6800-A2-GN22-30
Changing the Token Ring Configuration
The Token Ring package configuration can be changed using the ECU to specify 4 Mbps speed
and/or shielded cable. You should execute the ECU normally and follow the steps specified above
through Step 8. Continue with the following steps:
1. To view all configured resources and display the Detailed Slot Map:
PRESS: Alt + v
TYPE: d
2. The Detailed Slot Map lists the setting for each component of the system. Use the ↓↑ keys
to scroll down to Slot 6 to see the Token Ring card configuration and to highlight the
Interrupt field values.
PRESS: Enter
3. A Change Function Menu appears. Use the ↓↑ keys to select IRQ 10 Edge Triggered.
PRESS: Enter
4. The Detailed Slot Map again appears. Use the keys to highlight the Speed field values.
PRESS: Enter
5. A Change Function Menu appears. The speed is set to 16 Mbps. Use the ↓↑ keys to select
4 Mbps if your LAN runs at this speed.
PRESS: Enter
6. The Detailed Slot Map again appears. Use the ↓↑ keys to highlight the Media Type field
values.
PRESS: Enter
7. A Change Function Menu appears. The Media Type is set to unshielded. Use the keys to
select Shielded (STP) cable if that cable type has been physically connected from the
Token Ring card to the Multi-Access Unit (MAU).
PRESS: Enter
8. To exit from this configuration function,
PRESS: Alt + Enter
TYPE: x
Select Save configuration and exit by pressing the s key.
9. The following message appears.
Your configuration has been saved. If you need to change any switch or
jumper setting or install any boards and options, turn off your computer
and do so right now. If not, Press [Enter] to reboot (restart) your system.
PRESS: Enter
The system reboots.