Princeton 4411-0039-CE Webcam User Manual


 
106 MicroMAX System User Manual Version 6.C
Interface tab card
Type: the appropriate interface card. For this procedure, the selection is
High Speed PCI.
Cleans/Skips tab card
Number of Cleans: 1
Number of Strips per Clean: 512
Minimum Block Size: 2
Number of Blocks: 5
9. From
the Acquisition menu, select Experiment Setup and enter the
following settings:
Main tab card
Exposure Time: Enter a value. The exposure time can either be greater
than the readout time or it can be equal to the readout time. If you want
an exposure time > readout time, enter a value larger than the readout
time calculated when the virtual chip definition was downloaded. If you
want an exposure time = readout time, enter 000 sec.
Number of Images: Enter the desired number of images.
Use Region of Interest
Accumulations: 1
ADC tab card
Type: FAST
ROI Setup tab card: Make no changes to the settings on this tab card unless
y
ou have re-enabled Normal Operating Mode. ROI setup for Virtual Chip
(High Speed Mode) is performed through the Virtual Chip dialog box.
10. From
the Setup menu, select Virtual Chip, and enter the following settings:
High Speed Mode Enabled
Virtual Chip Definition: The settings below assume a 47x47 pixel virtual
chip. The X and Y dimensions are established by the external mask. The
virtual chip is fully flexible in the X direction. However, the set of choices
for the Y-dimension has been pre- selected for optimal performance. Note
that the origin point that Princeton Instruments uses for a CCD array is 1,1.
Chip Y Dimension: 47. Select this dimension from the drop down list.
Chip X Dimension: 47. Enter this dimension manually.