Filter
Top Products
Chapter 9 Troubleshooting 127
Securing the Detector-Controller Cable Slide Latch
Some Princeton Instruments Detector-Controller cables use a slide latch to secure the
Detector-Controller cable to the DETECTOR connector on the back of the ST-133.
Incorrectly plugging this cable into the connector and improperly securing the slide latch
may prevent communication with the MicroMAX (the camera may appear to stop working).
1. Before try
ing to plug in the cable, slide the latch up (toward Pin 1). Then, plug the
cable into the DETECTOR connector on the ST-133.
2. Slide the latch down. You m
ay hear a click when the latch locks.
3. Verify
that the connector is fully secured.
If you are having trouble sliding the latch, slightly
pull the connector out and then slide
the latch into its locked position.