Chapter 9
Troubleshooting
Do not attach or remove any cables while the MicroMAX system is powered on.
WARNING!
Introduction
The following issues have corresponding troubleshooting sections in this chapter.
Baseline Signal Suddenly Changes Page 112
Camera Stops Working Page 112
Camera1 (or similar name) in Camera Name field Page 112
Changing the ST-133's Line Voltage and Fuses Page 113
Controller is Not Responding Page 114
Cooling Troubleshooting Page 114
Data Loss or Serial Violation Page 115
Data Overrun Due to Hardware Conflict message Page 116
Data Overrun Has Occurred message Page 116
Demo is only Choice on Hardware Wizard:Interface dialog
(Versions 2.5.19.0 and earlier)
Page 117
Demo, High Speed PCI, and PCI(Timer) are Choices on Hardware
Wizard:Interface dialog (Versions 2.5.19.0 and earlier)
Page 118
Detector Temperature, Acquire, and Focus are Grayed Out
(Versions 2.5.19.0 and earlier)
Page 120
Error Creating Controller message Page 121
Error Occurs at Computer Powerup Page 121
No CCD Named in the Hardware Wizard:CCD dialog
(Versions 2.5.19.0 and earlier)
Page 124
Program Error message Page 124
Removing/Installing a Plug-In Module Page 125
Securing the Detector-Controller Cable Slide Latch Page 127
Serial violations have occurred. Check interface cable. Page 128
Shutter Malfunctions Page 128
111