Princeton 4411-0039-CE Webcam User Manual


 
76 MicroMAX System User Manual Version 6.C
Shutter opens
Shutter remains open
for preprogrammed
exposure time
System waits while
shutter closes
Shutter opens
Controller waits for
External Sync pulse
Controller waits for
External Sync pulse
(shutter preopen)
(shutter normal)
Figure 30. Showing Shutter "Preopen" & "Normal" Modes in External Sync Operation
Shutter (Normal)
Open Close Open Close Open Close
Read Read Read
Shutter (Preopen)
Open Close Open
Close
Open Close
External Sync
(negative polarity shown)
First wait
and exposure
Data
stored
Second wait
and exposure
Third wait
and exposure
Data
stored
Data
stored
t
exp
t
c
t
R
t
w1
NOT SCAN
Figure 31. External Sync Timing Diagram (- edge trigger)
The PreOpen mode is useful in cases where an External Sync pulse cannot be provided
5-28 msec before the actual signal occurs. Its main drawback is that the CCD is exposed
to any ambient light while the shutter is open between frames. If this ambient light is
constant, and the triggers occur at regular intervals, this background can also be
subtracted, providing that it does not saturate the CCD. As with the Normal Shutter
mode, accurate background subtraction may not be possible for the first frame.
Also note that, in addition to signal from ambient light, dark charge accumulates during
the “wait” tim
e (t
w
). Any variation in the external sync frequency also affects the amount
of dark charge, even if light is not falling on the CCD during this time.
Note: If EXT SYNC is still active at the end of the readout, the hardware will interpret
this as a second sync pulse, and so on.