Filter
Top Products
Chapter 4 System Setup 41
Figure 11. Camera Detection Wizard - Welcome dialog box
4. Follow the instructions on the dialog boxes to perform the initial hardware setup: this
wizard enters default parameters on the Hardware Setup dialog box tab pages and
gives you an opportunity to acquire a test image to confirm the system is working.
WinX Versions before 2.5.19.6: Run RSConfig.exe
1. Make sure the ST-133 is connected to the host com
puter and that it is turned on.
2. Run RSConfig from
the
Windows|Start|Programs|PI Acton menu or from the
directory where you installed WinView, WinSpec, or WinXTest.
3. When the RSConfig dialog box (Figure 12) appears, you can change the camera
nam
e to one that is more specific or you can keep the default name "Camera1".
When you have finished, click on the Done button.
Note: If the first camera in the list is not the "Princeton Style (USB2)", you will
need to edit the PVCAM.INI file created by RSConfig. See the instructions in
"Demo, High Speed PCI, and PCI(Timer) are Choices on Hardware
Wizard:Interface dialog (Versions 2.5.19.0 and earlier)", page 118.
Figure 12. RSConfig dialog box
4. Open the WinX application and, from Setup|Hardware…, run the Hardware
Setup wizard.