Filter
Top Products
Programming6-48
Line Spacing 1/6 Inch
ASCII Hex Decimal
P-Series SFCC
LPI;n
SFCC 2 SFCC 32 SFCC 50
Serial ESC 2
1B 32
27 50
Purpose
Sets line spacing to 6 lpi or as set by ESC A.
Comment The
value of
n
can be
6 or 8 only. In LPI mode using P-Series printer proto
Ć
col,
if n = 6, this command sets line spacing to
1/6 inch. V
alues of n other than
6
or 8 will cause an error message (Command Line Error
Messages are listed
on page 6-3).
SFCC/ESC 2 asserts n/72-inch line spacing as set by SFCC/ESC A (page
6-52).
If no distance has been set by SFCC/ESC A, the distance is 1/6 inch.
The control code line spacing selection will override the control panel line
spacing
setting.
Example The following example illustrates 1/6-inch line spacing and assumes that a
distance
has not been set by ESC A.