Filter
Top Products
6-65Programming
Skip-Over Perforation
ASCII Hex Decimal
P-Series N/A
Serial ESC
N n
1B 4E n
27 78 n
Purpose Selects
the number of lines (at the current line spacing) for the paper skip" at
the
bottom of the perforated page.
where
n = 1 to 127 to select the
number of lines to skip. If the value of n exceeds
the current forms length, it is ignored.
Comment The
actual distance set is the product of n" and the current line spacing. F
acĆ
tory default value disables skip-over perforation. The current default value
may
be set by the operator. Setting a new forms length (ESC C) resets skip-
over perforation to zero.
This feature is disabled whenever vertical tabs are set.
Skip-over perforation can also be selected from the control panel; however,
vertical
tabs
within the skip-over perforation zone, as set by the control pan
Ć
el, are ignored. The control code skip-over perforation setting from the host
computer
will override the control panel setting.