Filter
Top Products
3-5Configuration
Configuration Procedure
Most
configuration options are selected from the control panel menu. T
o change the
configura
Ć
tion from the control panel, the printer must be powered up, off line (OFFLINE READ
Y), and
the control panel ENTER switch enabled (unlocked). The current configuration may be exam
Ć
ined
- but not changed - by leaving the ENTER switch locked.
The
basic configuration procedure requires pressing MENU
DOWN and NEXT/PREV to ar
Ć
rive at the desired menu. The parameters associated with that menu are accessed by pressing
MENU
DOWN again, at which time
the currently active parameter or a submenu is displayed.
NEXT and PREV are used to sequentially list all the parameters or submenus available within
that
menu. When the currently active value is shown on the display, it will be
indicated with an
asterisk (*) next to it. Pressing ENTER selects the parameter visible on the display, and reĆ
places
the previous
parameter. The Control P
anel Configuration Diagram, which illustrates all
configuration menus and values, is provided at the end of this chapter. Thoroughly review
these
diagrams to understand the configuration menu hierarchy and the control panel buttons
to
select individual menus and parameter values.
The
following general procedure can be
used to reconfigure the printer from the control panel:
1. Obtain a current configuration printout as described in the Configuration Printout secĆ
tion
of this chapter.
2. Determine
the parameter values that must be changed to meet your requirements.
R
efer
to the Control Panel Configuration Diagram for an illustration of the parameter values
and
the procedure required to select and display the values.
3. Place
the printer off line and raise the printer
cover. Enable the ENTER switch by press
Ć
ing MENU UP and MENU DOWN simultaneously until the ENTER SWITCH NOT
LOCKED
message appears briefly in the LCD message display.
4. Select and display the desired menu by pressing MENU DOWN and then NEXT or
PREV
until the name of the menu appears in the LCD message display.
5. Select and display the required value(s) for the selected menu item by pressing MENU
DOWN
and then NEXT or PREV until the value appears in the LCD message display.
6.
Save the selected value(s) by pressing ENTER.
7. After all parameters have been changed as required, select SAVE PARAMETERS from
Level
II of the main
menu and press ENTER. This will save the current parameter values
as the powerup values.
8. Press
CLEAR to place the printer off line. Disable the ENTER switch by pressing MENU
UP
and MENU DOWN simultaneously. ENTER SWITCH LOCKED will appear briefly
in
the LCD message display.
9.
Close the printer cover and place the printer on line.