Filter
Top Products
Installation11-2
A label on the back of the printer near
the power cord indicates the voltage and frequency re
Ć
quirements. The printer must be connected to the specified power source, either 110, 220 or
240 volts at 50 to 60 Hz. Line voltage can vary
10%. The printer automatically senses and
adjusts itself to conform to the proper voltage. Primary circuit protection is contained in the
printer.
Consult an electrician if printer operation affects local electrical lines.
- WARNING -
The power cord requires an I.E.C. (hot) connector to mate to the receptacle on the
rear
panel of the printer
. The hot connector includes a polarizing
key which prevents
the use of cordsets that are not of the correct rating for the printer.
- WARNUNG -
Das Stromkabel benötigt einen I.E.C. (spannungsführenden) Stecker, der in die
Steckdose an der hinteren Wand des Druckers passt. Der spannungsführende
Stecker kommt mit einem Nulleiter, der die Benutzung von Stromkabeln ohne die
korrekte Nennleistung für den Drucker verhindert.
Site Requirements
When selecting a printer location, consider interface requirements, power requirements, and
environmental factors. Select a location that has the proper power source available and is
within the maximum cable length specifications for interfacing with the host computer. The
printer
is designed to operate in a relatively dust free environment such as a computer room or
business
office with an ambient temperature of 5
_
to
40
_
C
(41
_
to
104
_
F)
and a relative
humidity
of 10% to 90%. The site selected for the printer must also allow air to circulate freely
all
around the printer. A minimum of 3 feet clearance behind the printer should be provided to
allow
air circulation and easy access to the paper stacking area. Figure 11-1 illustrates the
site
requirements.
- CAUTION -
The warranty may be voided if adequate printer ventilation is not provided. OverĆ
heating and serious damage to printer components can occur if the air vents at
the
sides and bottom of the printer are blocked.
- VORSICHT -
Die Gewährleistung könnte ungültig werden, wenn nicht genügen Druckerlüftung
vorhanden ist. Überhitzung und schweren Schaden der Druckerkomponenten
könnte vorkommen, wenn die Entlüftungsschlitze an den Seiten und unten am
Drucker blockiert sind.