Filter
Top Products
6-49Programming
Line Spacing 1/8 Inch (8 lpi)
ASCII Hex Decimal
P-Series SFCC
LPI;n
SFCC 0 SFCC 30 SFCC 48
Serial ESC 0
1B 30
27 48
Purpose
Specifies continuous line spacing at 1/8-inch increments (8 lpi).
Comment When the 1/8-inch line spacing control code is received, all lines will be
printed
at 8 lpi until a new line spacing is selected or power is reset. The con
Ć
trol
code line spacing selection will override the control panel line spacing set
Ć
ting and 8 lpi will be reflected on the display when the 6/8 LPI switch is
pressed.
The
value of
n
can be
6 or 8 only. In LPI mode using P-Series printer proto
Ć
col,
if n = 8, this command sets line spacing
to 1/8 inch. V
alues of n other than
6
or 8 will cause an error message (Command Line Error
Messages are listed
on page 6-3).
Example
The following example illustrates 1/8-inch line spacing.